How to Update Samsung Galaxy Y S5360 with Official Android 2.3.6 Firmware...

How to Update Samsung Galaxy Y S5360 with Official Android 2.3.6 Firmware [Ultimate Guide]

UHLJ1 Android 2.3.6 Gingerbread official firmware is now available for Galaxy Y S5360L in Panama. You can update your Galaxy Y S5360L to this firmware build either through OTA or via Kies utility officially. However, if officially recommended process not work for you then continue reading this guide to how to install UHLJ1 Android 2.3.6 Gingerbread firmware on your Galaxy Y S5360L

Root-Samsung-Galaxy-Y-Duos

Read the following instructions carefully while updating your Samsung Galaxy Y to Android 2.3.6 Gingerbread. Please note that each and every step mentioned in this article is important

To update Samsung Galaxy Y S5360 to Android 2.3.6 Gingerbread, follow our guide below.

Disclaimer: The procedure given in this tutorial is considered as risky and may cause damage to your phone. It is recommended that you should not follow it unless you are familiar with these things. Follow this guide completely at your own risk.

I. Before You Begin:

1. The following procedure works for Samsung Galaxy Y S5360 smartphones.

2. Make sure your device have at least 80% battery power.

3. You must have ClockworkMod Recovery installed on your device.

4. Make sure USB Debugging is enabled

II. Downloading Required Files:

  1. Android 2.3.6 S5360LUHLJ1 for Galaxy Y GT-S5360L
  2. Odin 3.07

III. Install Android 2.3.6 Gingerbread ROM:

1. Extract Firmware zip file and you will get a .tar file and some other files.

2. Extract Odin zip file and you will get Odin3 v3.07.exe along with few other files.

3. Switch off your Galaxy Y

4. Now, put the Galaxy Y in Download Mode by pressing and holding the Volume Up key and Power button.

5. Then, a warning message appears, press the Volume Down key to continue.

6. Now run Odin3 v3.07.exe as an Administrator because Admin privileges is required to complete the process smoothly.

7. Now connect your Galaxy Y with your PC using USB cable.

8. Then a message will arrive under Odin’s message box in the bottom left saying “Added!!

9. Select these files in Odin at respective tabs from extracted firmware folder:

  • Click the PDA Button, and select the .tar file here with *code* appearing in its name
  • Click the Phone Button, and select file with *modem* in its name (leave if there is no such file)
  • Click the CSC Button, and select file with *csc* in its name (leave if there is no such file)
  • Click the PIT Button, and select the .pit file. Use only if you got it while extracting in step 1 above, otherwise ignore it.

10. In Odin window, make sure Auto Reboot and F. Reset Time checkboxes are selected. Also, make sure that Re-Partition checkbox is selected, only if you are using a .pit file.

11. Double check everything that we mentioned in Step 9 & Step 10 above. Now, once satisfied hit the START button to begin the flashing process.

12.    Once flashing completed, you will see a PASS message with green background in the left-most box at the very top of the Odin. The phone will then automatically rebooted and soon you will see the Samsung logo. You can then unplug the USB cable to disconnect your device from computer.

Congrats! Your Samsung Galaxy Y I9305 should now run on Android 2.3.6 Gingerbread.

Go to Settings > about phone to verify this firmware upgrade.

2 COMMENTS

Leave a Reply